This Momentary Tactile Push Button Module DC 5V 12V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module of the push button is a fully-fledged device with which you can install it immediately in the project, without using a pull-up or tightening resistances, because this is already in the circuit. The button together with the resistor is located on the board, where there are holes for installation. The built-in resistor has a rating of 10 kΩ. The module is designed for two contacts: when pressed, they are closed and open when released. There are also 3 outputs on the board: I, S, 5V. Contact I is connected to the common wire of the circuit, S is the output of the module and 5V is connected to the power supply. Specifications: Operating Voltage 5V-12V DC Contact Resistance ≤50 MΩ Operating Temperature Range (°C) -25 to 105 Mech. & Electrical Lifecycle ≈ 100,000 PCB thickness 1.5mm Length 20mm Width 16mm Height 7mm Weight 1 gm Package Includes: 1 x Momentary Tactile Push Button Module DC 5V Switch. *Product Images are shown for illustrative purposes only and may differ from actual product.
